Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: hsieh

Forum: OpenFOAM Pre-Processing

April 18, 2006, 15:38

Replies: 19

Mesh to points cells faces and boundaries files

Views: 6,095

Posted By hsieh

Hi, Billy, I just found out

Hi, Billy,

I just found out that I-DEAS does not support pyramid. I have a part with two volumes, one volume was meshed with Hex and one volume was meshed with Tet. So, on one face of some Hex...

Forum: OpenFOAM Pre-Processing

April 18, 2006, 15:00

Replies: 19

Mesh to points cells faces and boundaries files

Views: 6,095

Posted By hsieh

Hi, Billy, It looked like y

Hi, Billy,

It looked like you have successfully converted your mesh to gmsh format and then converted to OpenFOAM format using gmshToFoam. I have a mesh exported to Ansys format from I-DEAS. I...

Forum: OpenFOAM Pre-Processing

May 4, 2005, 10:32

Replies: 19

Mesh to points cells faces and boundaries files

Views: 6,095

Posted By hsieh

Hi, Mattijs, Can you give a

Hi, Mattijs,

Can you give a brief explaination how autoPatch works? I took a look at it. It requires input of an angle. Does it mean that it will try to find the boundary faces with the...

Forum: OpenFOAM Pre-Processing

April 29, 2005, 13:33

Replies: 19

Mesh to points cells faces and boundaries files

Views: 6,095

Posted By hsieh

Hi, Billy, I have been usin

Hi, Billy,

I have been using netgen (with step format generated using SolidWorks). I have built complex geometry meshes without any problem. There are two drawbacks assoicated with netgen:
...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 16:10.