Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: SirWombat

Forum: OpenFOAM Meshing & Mesh Conversion

August 30, 2012, 09:23

Replies: 7

[snappyHexMesh] snappyHexMesh does not snap to corner

Views: 3,916

Posted By SirWombat

hmm ... too bad ... There is this thread...

hmm ... too bad ...

There is this thread here, but the issue should have been resolved:...

Forum: OpenFOAM Meshing & Mesh Conversion

August 30, 2012, 08:51

Replies: 7

[snappyHexMesh] snappyHexMesh does not snap to corner

Views: 3,916

Posted By SirWombat

i see ... have you checked that all your feature...

i see ... have you checked that all your feature edges are there?

to check using paraFoam you will have to convert the eMesh-File to an obj-File like this
surfaceFeatureConvert...

Forum: OpenFOAM Meshing & Mesh Conversion

August 30, 2012, 06:08

Replies: 7

[snappyHexMesh] snappyHexMesh does not snap to corner

Views: 3,916

Posted By SirWombat

Try to use featureEdges. In case you did you may...

Try to use featureEdges. In case you did you may want to ease/alter your quality settings.

Compared to the rest of the domain your edges seem to have a very high cell resolution. If you use...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 08:00.