CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Members List Search Today's Posts Mark Forums Read

Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: Andyjoe
Forum: OpenFOAM Meshing & Mesh Conversion April 4, 2010, 20:50
Replies: 10
Views: 16,440
Posted By Andyjoe
Hello, it should be no problem, that you have...

Hello,
it should be no problem, that you have only 2 processors. You dont have to run the decomposePar routine. Consequently the case runs only on one core. But of course the decomposeParDict file...
Forum: OpenFOAM Meshing & Mesh Conversion January 28, 2010, 15:02
Replies: 10
Views: 16,440
Posted By Andyjoe
I try 2*10^-10s, and it is still running scince a...

I try 2*10^-10s, and it is still running scince a few hours. I think I have to stop the simulation tomorrow. The problem is, that the time I can simulate is only limited, and in 10^-6s there isn't...
Forum: OpenFOAM Meshing & Mesh Conversion January 28, 2010, 09:08
Replies: 10
Views: 16,440
Posted By Andyjoe
Thank you for replying. I used a time step of...

Thank you for replying. I used a time step of 2*10^-8s first. Because this is very small, I tried an timestep of 2*10^-5s too, of course it crashes earlier then. Do you think it would make sense, to...
Forum: OpenFOAM Meshing & Mesh Conversion January 26, 2010, 13:16
Replies: 10
Views: 16,440
Posted By Andyjoe
Thank you very much for your reply, it helped a...

Thank you very much for your reply, it helped a lot, so the first qestion is answered now.
Forum: OpenFOAM Meshing & Mesh Conversion January 26, 2010, 09:24
Replies: 10
Views: 16,440
Posted By Andyjoe
Trying to understand the motorBike tutorial

Hello,

scince I'm able to configure an run simple OpenFoam cases, I went through the motorBike tutorial the last days. Everything worked. So I changed the stl file with a new geometry made in...
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT -4. The time now is 17:40.