Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: CoolHand

Forum: OpenFOAM Pre-Processing

August 13, 2014, 21:10

Replies: 2

Proper BCs for 3D exterior plate flow with simpleFoam?

Views: 1,134

Posted By CoolHand

Thanks for your reply, I have examined this...

Thanks for your reply,

I have examined this case but "far enough" is exactly the problem. I want to move the walls closer to the object without having flow acceleration from the constriction.

Forum: OpenFOAM Pre-Processing

August 13, 2014, 19:06

Replies: 2

Proper BCs for 3D exterior plate flow with simpleFoam?

Views: 1,134

Posted By CoolHand

Proper BCs for 3D exterior plate flow with simpleFoam?

If I want to run a simulation with a atmBoundaryLayerInletVelocity for the inlet and a flat plate with an object on it at the bottom but I'm not concerned with flow at the side walls or upper wall,...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 15:40.