Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Ahmed Khattab

Forum: OpenFOAM Pre-Processing

June 7, 2012, 12:21

Replies: 27

problem in toposet

Views: 20,430

Posted By Ahmed Khattab

Hi Rehan, 1- invert is used to specify...

Hi Rehan,

1- invert is used to specify region which is the rest of the domain instead of specify it as every region you can just say that it is the invert of all regions in the domain.

2-...

Forum: OpenFOAM Pre-Processing

June 4, 2012, 00:31

Replies: 27

problem in toposet

Views: 20,430

Posted By Ahmed Khattab

you are welcome.

you are welcome.

Forum: OpenFOAM Pre-Processing

May 29, 2012, 05:50

Replies: 27

problem in toposet

Views: 20,430

Posted By Ahmed Khattab

Hi Kettnera, i experienced same problem before,...

Hi Kettnera,
i experienced same problem before, after processing chtMultiRegionFoam solver, as usual type paraFoam and paraview will open then from toolbar choose file then open, it will open window...

Forum: OpenFOAM Pre-Processing

May 28, 2012, 11:44

Replies: 27

problem in toposet

Views: 20,430

Posted By Ahmed Khattab

Dear Kid, topoSet is used to split your mesh...

Dear Kid,

topoSet is used to split your mesh into many regions so you can give properties to the entire region not only for patches. i used for the first time for heat transfer problem in...

Forum: OpenFOAM Pre-Processing

May 28, 2012, 04:18

Replies: 27

problem in toposet

Views: 20,430

Posted By Ahmed Khattab

Dears, finally i have found the problem. in...

Dears,

finally i have found the problem. in blockMeshDict i have converted units to centimeter so i have wrote 0.1m as 10. in toposet i used same value but it red it as meters so 10 became 10m. it...

Forum: OpenFOAM Pre-Processing

May 17, 2012, 14:21

Replies: 27

problem in toposet

Views: 20,430

Posted By Ahmed Khattab

problem in toposet

Hi Foamers,

i'm trying to run chtMultiRegionFoam on my own case, it's a tube with outer diameter 11cm, inner diameter 10cm and length 100cm i created a cylinder in blockMesh file with outer...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 21:00.