Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: obaid69

September 10, 2014, 09:38

Replies: 7

Views: 1,474

Posted By obaid69

Thanks Maxime Perelli for the response. I would...

Thanks Maxime Perelli for the response. I would be pleased to find the way back from face split but looks like its a one-way operation.
Thanks again
Regards,
Obaid

Forum: ANSYS Meshing & Geometry

September 9, 2014, 09:40

Replies: 7

Views: 1,474

Posted By obaid69

Actually I did Face Split with Edge by copying...

Actually I did Face Split with Edge by copying the edges to each channel and then split face.
What I erred is not to recheck each channel before going to the next so that I could undo the mistakes....

Forum: ANSYS Meshing & Geometry

September 8, 2014, 09:19

Replies: 7

Views: 1,474

Posted By obaid69

Gambit cleanup geometry problem

Take a look at fluid domain. (picture C)

Forum: ANSYS Meshing & Geometry

September 8, 2014, 08:18

Replies: 7

Views: 1,474

Posted By obaid69

Gambit cleanup geometry problem

Dear Maxime Perelli,
Kindly find the attached images of full domain (B) and a closeup (A).
Regards,
Obaid

Forum: ANSYS Meshing & Geometry

September 8, 2014, 05:22

Replies: 7

Views: 1,474

Posted By obaid69

Gambit cleanup geometry problem

Hello,
I am working with Gambit 2.3.16 to make a geometry of flow channel assembly. I am stuck after some mistakes done during face splitting which results in hard lines (dangling) that formed with...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 09:47.