Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: antonio_ing

Forum: OpenFOAM Running, Solving & CFD

February 23, 2009, 04:58

Replies: 8

Torque in a sliding interface mesh

Views: 1,610

Posted By antonio_ing

looking at the forces, the cen

looking at the forces, the centre of rotation is correct (0 0 0) and i can obtain the same result with the forceCoeffs. but the problem remains... :-(

Forum: OpenFOAM Running, Solving & CFD

February 23, 2009, 04:13

Replies: 8

Torque in a sliding interface mesh

Views: 1,610

Posted By antonio_ing

actually there is something st

actually there is something strange since the torque is lower than expected and, also, this is a 2d geometry so the only non zero torque component should be Mz but in this case all the three torque...

Forum: OpenFOAM Running, Solving & CFD

February 23, 2009, 03:36

Replies: 8

Torque in a sliding interface mesh

Views: 1,610

Posted By antonio_ing

thx i was unsure if this co

thx

i was unsure if this code will work on rotating patches. I'll tell you soon... :-)

Forum: OpenFOAM Running, Solving & CFD

February 23, 2009, 03:19

Replies: 8

Torque in a sliding interface mesh

Views: 1,610

Posted By antonio_ing

Hi foamers i would like to

Hi foamers

i would like to measure the torque in a certain patch which belongs to a rotating region. I simulate a turbulent flow (with a standard kepsilon model) around some rotating airfoils...

Forum: OpenFOAM Running, Solving & CFD

February 11, 2009, 07:53

Replies: 8

Torque in a sliding interface mesh

Views: 1,610

Posted By antonio_ing

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 01:51.