Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: pankos

Forum: ANSYS Meshing & Geometry

February 20, 2011, 05:37

Replies: 8

Periodic boundaries

Views: 2,218

Posted By pankos

All periodic conditions are problems of solver...

All periodic conditions are problems of solver and not Mesh generator. Simply, the mesh generator determine the edges which have Periodic B.C.
If was problem of mesh generator must be put tha same...

Forum: ANSYS Meshing & Geometry

February 18, 2011, 05:59

Replies: 8

Periodic boundaries

Views: 2,218

Posted By pankos

yes. The continuity of a side is other side. i...

yes. The continuity of a side is other side. i dant know, i wiil try to make this in my code but of course without any generallity.

Forum: ANSYS Meshing & Geometry

February 18, 2011, 02:14

Replies: 8

Periodic boundaries

Views: 2,218

Posted By pankos

Ok. As shown, the only way is this. It must be...

Ok. As shown, the only way is this. It must be construct only by code.

But, if in connectivity list of elements which derived by Mesh generator, has same number (indexing )of nodes at two face...

Forum: ANSYS Meshing & Geometry

February 17, 2011, 10:13

Replies: 8

Periodic boundaries

Views: 2,218

Posted By pankos

No, i dont use FLUENT, but code which i made it....

No, i dont use FLUENT, but code which i made it. Due to i can take mesh information only by ASCII neutral file (Generic).
If i select Generic at solver menou , it doesnt appear any periodic...

Forum: ANSYS Meshing & Geometry

February 17, 2011, 02:56

Replies: 8

Periodic boundaries

Views: 2,218

Posted By pankos

Periodic boundaries

Is there any way to make periodic mesh in gambit? With other words, the elements on a side to connect with elements of other side as there is continuity. Therefore in NEUTRAL file (which export the...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 01:10.