Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Rophys

Forum: OpenFOAM Meshing & Mesh Conversion

October 12, 2015, 06:37

Replies: 28

[Commercial meshers] Problem converting fluent mesh

Views: 11,937

Posted By Rophys

Hi wyldckat, Sorry for my later response. ...

Hi wyldckat,

Sorry for my later response.

You were right! I fixed the problem and now the mesh looks fine. I didn't have any other problem with negative volumes :D

Thanks again for your...

Forum: OpenFOAM Meshing & Mesh Conversion

September 19, 2015, 17:23

Replies: 28

[Commercial meshers] Problem converting fluent mesh

Views: 11,937

Posted By Rophys

Hi Bruno, I am using ICEM to produce the...

Hi Bruno,

I am using ICEM to produce the mesh. I guess, it is possible to give a certain orientation to the cells, as you mentioned earlier. I will save the mesh with different orientation and...

Forum: OpenFOAM Meshing & Mesh Conversion

September 16, 2015, 14:10

Replies: 28

[Commercial meshers] Problem converting fluent mesh

Views: 11,937

Posted By Rophys

Thanks Bruno for your response. I manage to...

Thanks Bruno for your response.

I manage to export from fluent to OpenFoam; however, when I check the mesh (command checkMesh), I have 5 failures (see below). In addition, when I initialized the...

Forum: OpenFOAM Meshing & Mesh Conversion

August 26, 2015, 15:32

Replies: 28

[Commercial meshers] Problem converting fluent mesh

Views: 11,937

Posted By Rophys

Hi all, Did anyone solved the problem with...

Hi all,

Did anyone solved the problem with the mesh conversion from fluent to OpenFOAM ?

I am getting the same error cited earlier in this thread but seems that nobody solved it, right ? Below...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 09:36.