Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: iampolaris

Forum: OpenFOAM Community Contributions

August 3, 2011, 23:28

Replies: 7

[swak4Foam] GroovyBC problem in the defining inlet velocity

Views: 3,756

Posted By iampolaris

Thank you very much! After following your advice,...

Thank you very much! After following your advice, i have checked the errors and found that i have wrongly defined the boundary and interfacialproperties. But, as i redefined the boundaryfield in...

Forum: OpenFOAM Community Contributions

August 2, 2011, 08:27

Replies: 7

[swak4Foam] GroovyBC problem in the defining inlet velocity

Views: 3,756

Posted By iampolaris

Bernhard, Thank you for you reply! As you...

Bernhard, Thank you for you reply!
As you pointed out, It's the error that i deleted the top of the file by accident. However, after correcting the mistake and running the case, there was another...

Forum: OpenFOAM Community Contributions

August 1, 2011, 23:32

Replies: 7

[swak4Foam] GroovyBC problem in the defining inlet velocity

Views: 3,756

Posted By iampolaris

GroovyBC problem in the defining inlet velocity

Hello, every one!
As defining inlet velocity of a two-phase flow bed, in which the voidage is constant, i need to ensure that the inlet mass flux of one phase is equal to the outlet flux from the...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 05:49.