Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: wyldckat

Forum: OpenFOAM Meshing & Mesh Conversion

October 5, 2011, 09:41

Replies: 8

[snappyHexMesh] sHM problem

Views: 1,651

Posted By wyldckat

Hi Stephane, OK, then first mesh only the...

Hi Stephane,

OK, then first mesh only the castellatedMesh stage. Check which cube-like cells are the ones at fault.
The key detail is whether there are cell vertexes that fall on top of the...

Forum: OpenFOAM Meshing & Mesh Conversion

October 3, 2011, 10:50

Replies: 8

[snappyHexMesh] sHM problem

Views: 1,651

Posted By wyldckat

Hi Stephane, I've just remembered that this...

Hi Stephane,

I've just remembered that this problem might be overcome by adjusting the tolerances. Check the following file in OpenFOAM's...

Forum: OpenFOAM Meshing & Mesh Conversion

October 1, 2011, 12:16

Replies: 8

[snappyHexMesh] sHM problem

Views: 1,651

Posted By wyldckat

Hi Stephane, Mmm... if the surface for each...

Hi Stephane,

Mmm... if the surface for each of those two blades are really water tight, then it might be a numerical problem. Are you able to isolate the each one of those damaged blades into...

Forum: OpenFOAM Meshing & Mesh Conversion

September 26, 2011, 10:47

Replies: 8

[snappyHexMesh] sHM problem

Views: 1,651

Posted By wyldckat

Hi Stephane, Probably there is a small hole...

Hi Stephane,

Probably there is a small hole in the filled blade. Google:openfoam "admesh"It should show you a few solutions for plugging the hole(s).

Best regards,
Bruno

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 07:02.