Forum: OpenFOAM
September 11, 2010, 23:59
|
Replies: 19
Views: 8,537
Hi everyone,
I had to do another install on...
Hi everyone,
I had to do another install on another computer and this time it took me literally less than ten minutes, maybe even less than five.
I was running Ubuntu 10.04.
1) First get...
|
Forum: OpenFOAM
September 8, 2010, 10:47
|
Replies: 19
Views: 8,537
Ok, my computer has been off for a while (so I...
Ok, my computer has been off for a while (so I restarted it), and I changed the openmpi version in OpenFOAM-1.5-dev/src/settings.sh back to 1.2.6, recompiled, tried blockMesh, icoFoam, paraFoam, and,...
|
Forum: OpenFOAM
September 8, 2010, 01:14
|
Replies: 19
Views: 8,537
|
Forum: OpenFOAM
September 7, 2010, 19:47
|
Replies: 19
Views: 8,537
|
Forum: OpenFOAM
September 7, 2010, 18:44
|
Replies: 19
Views: 8,537
Hi guys,
Well, I got to the last step in the...
Hi guys,
Well, I got to the last step in the directions I posted in my last post. It's a testing step. blockMesh didn't work.
I got a less-than-ceremonious ending when compiling (no 'done' or...
|
Forum: OpenFOAM
September 7, 2010, 00:40
|
Replies: 19
Views: 8,537
Hi guys,
I am in the process of installing...
Hi guys,
I am in the process of installing 1.5-dev, and I am not sure what to do for the compiling step (Basically step 5 in Elvis's post above). I have retrieved the 1.5-dev (r1823) files via...
|
Forum: OpenFOAM
September 6, 2010, 18:05
|
Replies: 19
Views: 8,537
|
Forum: OpenFOAM
September 6, 2010, 18:04
|
Replies: 19
Views: 8,537
Hey guys,
Can one say generally whether MRF...
Hey guys,
Can one say generally whether MRF or sliding interface is more accurate when applied to a 2D rotor-stator simulation? If the computation times are similar within about one order of...
|
Forum: OpenFOAM
September 6, 2010, 11:37
|
Replies: 19
Views: 8,537
|
Forum: OpenFOAM
September 6, 2010, 10:01
|
Replies: 19
Views: 8,537
Sliding Interface in OpenFoam?
The following is part of my correspondence with 'enquiries@opencfd.co.uk':
"...In which case it is likely you will need to perform these calculations using a
sliding-interface. This...
|