Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: JanKubata

Forum: OpenFOAM

December 7, 2010, 10:10

Replies: 6

dieselSpray problem

Views: 1,418

Posted By JanKubata

I'm simulating something like burner - injector...

I'm simulating something like burner - injector is in the center of one side and outflow is on oposite one. The position of injector is ok, because with smaller number of cells with same geometry I...

Forum: OpenFOAM

December 7, 2010, 09:55

Replies: 6

dieselSpray problem

Views: 1,418

Posted By JanKubata

definedInjectorProps { ...

definedInjectorProps
{
position ( -0.0003 0.0491 -0.0271386 );
direction ( -1 0 0 );
diameter 0.45e-3;
...

Forum: OpenFOAM

December 7, 2010, 09:42

Replies: 6

dieselSpray problem

Views: 1,418

Posted By JanKubata

I'm using this setup: atomizationModel...

I'm using this setup:
atomizationModel blobsSheetAtomization;
includeOscillation on;
breakupModel ReitzKHRT;
injectorModel hollowConeInjector;
collisionModel trajectory;
evaporationModel...

Forum: OpenFOAM

December 7, 2010, 03:49

Replies: 6

dieselSpray problem

Views: 1,418

Posted By JanKubata

dieselSpray problem

I have a problem with modeling of diesel spray. I have few cases with almost same geometry, but with different number of cells - 0.5M, 0.87M and 3M. Initial conditions are same for all cases.
If...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 01:09.