Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: milton.tafadzwa

Forum: ANSYS Meshing & Geometry

March 17, 2009, 01:37

Replies: 7

Splitting tube face into two

Views: 3,246

Posted By milton.tafadzwa

Thanks, I have located where I was making a...

Thanks, I have located where I was making a mistake and the problem is solved.
For interest sake how do I go about to send the .dbs file. This is my first time using this software.

Forum: ANSYS Meshing & Geometry

March 16, 2009, 19:22

Replies: 7

Splitting tube face into two

Views: 3,246

Posted By milton.tafadzwa

The top wall is there on the grid but is missing...

The top wall is there on the grid but is missing on the list surfaces, so am unable to set boundary conditions on it. I did create it in Gambit.

Forum: ANSYS Meshing & Geometry

March 16, 2009, 09:41

Replies: 7

Splitting tube face into two

Views: 3,246

Posted By milton.tafadzwa

No I did not receive any warning. I have three...

No I did not receive any warning. I have three wall-BC the top wall, bottom wall and open end on one end of the tube.

Forum: ANSYS Meshing & Geometry

March 16, 2009, 08:43

Replies: 7

Splitting tube face into two

Views: 3,246

Posted By milton.tafadzwa

Splitting tube face into two

Dear friends
I have created a tube with height 1420mm and radius 37mm. I have split the tube face into two (lengthwise at centre) so that I have a top face (top wall) and a bottom face (bottom...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 23:39.