Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: PSYMN

Forum: ANSYS Meshing & Geometry

December 8, 2010, 09:54

Replies: 13

Meshing aifoil in ICEM

Views: 5,734

Posted By PSYMN

The names don't matter. You can call the sphere...

The names don't matter. You can call the sphere "SPHERE", but it will just be a wall. You should have an inlet and an outlet... I am sure there is a tutorial out there on all the transient...

Forum: ANSYS Meshing & Geometry

December 5, 2010, 09:39

Replies: 13

Meshing aifoil in ICEM

Views: 5,734

Posted By PSYMN

Step by step...

Yes, of course it is possible, but ICEM CFD is a mesh generator not a simulator. (the CFD part of the name is unfortunate).

I assume you plan to use 2D? Basically a circle in a box far field?
...

Forum: ANSYS Meshing & Geometry

October 16, 2009, 15:50

Replies: 13

Meshing aifoil in ICEM

Views: 5,734

Posted By PSYMN

The simple answer is that the range is just...

The simple answer is that the range is just inverted... In Gambit, quality of 0 is good, 1 is bad. In ICEM CFD, 1 is good, 0 is bad.

However, the metrics are each calcualted a little bit...

Forum: ANSYS Meshing & Geometry

October 16, 2009, 15:16

Replies: 13

Meshing aifoil in ICEM

Views: 5,734

Posted By PSYMN

Differences...

The geometry tools for each are completely different.

ICEM CFD is a surface based modeler built on DDN technology (ICEM SURF). Everything is built bottom up, which provides a lot of flexibilty,...

Forum: ANSYS Meshing & Geometry

October 11, 2009, 21:41

Replies: 13

Meshing aifoil in ICEM

Views: 5,734

Posted By PSYMN

Try a tutorial...

I assume you are using Hexa... Blocking requires a series of splitting, associating, removing blocks, assigning edge params (mesh sizes), etc.

Once you get going, it is easy, but CFD-Online can't...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 06:23.