Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: lnk

Forum: ANSYS Meshing & Geometry

July 10, 2012, 06:48

Replies: 11

[ANSYS Meshing] Question about mesh generation for a wedge

Views: 3,926

Posted By lnk

Thank you very much! I've done it!:)

Thank you very much! I've done it!:)

Forum: ANSYS Meshing & Geometry

July 9, 2012, 17:13

Replies: 11

[ANSYS Meshing] Question about mesh generation for a wedge

Views: 3,926

Posted By lnk

I think Flotus is correct. There is a significant...

I think Flotus is correct. There is a significant difference between our meshes. I learnt your link but still not able to generate meshes like you. May I ask you to show your block?

Best regards...

Forum: ANSYS Meshing & Geometry

July 8, 2012, 16:14

Replies: 11

[ANSYS Meshing] Question about mesh generation for a wedge

Views: 3,926

Posted By lnk

Thank you very much for your answer. I tried to...

Thank you very much for your answer. I tried to make the meshes again but still not able not generate high quality mesh as you did. Here is my mesh. You can see I always have problem at the frontal...

Forum: ANSYS Meshing & Geometry

July 8, 2012, 12:00

Replies: 11

[ANSYS Meshing] Question about mesh generation for a wedge

Views: 3,926

Posted By lnk

Thanks for your answer. The mesh need to be...

Thanks for your answer. The mesh need to be inside the wedge. As you can see in the attachment picture. The hexa girds have bad quality at the up front part of the wedge. How could I improve that?
...

Forum: ANSYS Meshing & Geometry

July 8, 2012, 11:29

Replies: 11

[ANSYS Meshing] Question about mesh generation for a wedge

Views: 3,926

Posted By lnk

Question about mesh generation for a wedge

Hi,

I'd like to generate high quality mesh for a wedge by ICEM? (You can see it at the attachment. The flow is from left to bottom.) May I ask what kind of mesh would you recommend me to generate?...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 01:55.