Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: PedroC

Forum: ANSYS Meshing & Geometry

February 22, 2011, 05:16

Replies: 19

[ICEM] Can't create prism layer on 2D extruded mesh

Views: 11,815

Posted By PedroC

Prism

Hi Simon. Yes I flagged prism on the Part Mesh Setup and I set the number of layers globally. I'll attach the error log on a txt because it wouldn't fit here. This log is from a 2D surface mesh which...

Forum: ANSYS Meshing & Geometry

February 21, 2011, 16:38

Replies: 19

[ICEM] Can't create prism layer on 2D extruded mesh

Views: 11,815

Posted By PedroC

Prism

Well, I did the following. I extruded the geometry in the first place. I copied the fluid surface on the oposite face in order to have a closed volume. I meshed the volume with a tetra/mixed octree...

Forum: ANSYS Meshing & Geometry

February 21, 2011, 08:55

Replies: 19

[ICEM] Can't create prism layer on 2D extruded mesh

Views: 11,815

Posted By PedroC

Thank you very much for your response Simon. If I...

Thank you very much for your response Simon. If I try your first option, which I already have, I get the error messages:

shells 10068 and 10068 not consistently oriented
expecting 2 shells on...

Forum: ANSYS Meshing & Geometry

February 20, 2011, 20:38

Replies: 19

[ICEM] Can't create prism layer on 2D extruded mesh

Views: 11,815

Posted By PedroC

Can't create prism layer on 2D extruded mesh

Hello. I am relatively new to ICEM and I've been searching similar cases on this forum for days with no luck. I'm using 12.1.

I have a problem whenever I try to create a prism layer on my tri...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 16:33.