Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: jsm

Forum: ANSYS Meshing & Geometry

June 26, 2012, 09:22

Replies: 11

[DesignModeler] 3d irregular volume from XYZ coordinates?

Views: 5,719

Posted By jsm

Hi, You should have four named...

Hi,

You should have four named selections - inlet, outlet, outerwall and free surface (interior face - that you are telling between two bodies). But you have only three parts. It gives some...

Forum: ANSYS Meshing & Geometry

June 26, 2012, 08:31

Replies: 11

[DesignModeler] 3d irregular volume from XYZ coordinates?

Views: 5,719

Posted By jsm

Hi, Did you checked this ? In Fluent...

Hi,

Did you checked this ? In Fluent boundary condition panel, for this particular surface, you can click the "Type" pop down menu and check there is interior option is available.

...

Forum: ANSYS Meshing & Geometry

June 26, 2012, 07:53

Replies: 11

[DesignModeler] 3d irregular volume from XYZ coordinates?

Views: 5,719

Posted By jsm

Hi, You are almost done. So you have...

Hi,

You are almost done. So you have two bodies separately right?
Just select both bodies in DM and right click and select "form new part" (I dont remember exact word). Then refresh the...

Forum: ANSYS Meshing & Geometry

June 26, 2012, 04:55

Replies: 11

[DesignModeler] 3d irregular volume from XYZ coordinates?

Views: 5,719

Posted By jsm

Hi Bennett, It looks like you are...

Hi Bennett,

It looks like you are creating surface from lot of points data and meshing this surface in ansys mesher.

From the image shown by you, I could not see any mistakes. Could...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 12:04.