Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: jsm

Forum: ANSYS Meshing & Geometry

September 17, 2009, 07:07

Replies: 8

[ICEM] Coarse mesh nearer to curves

Views: 6,034

Posted By jsm

Hi, Thanks a lot for your...

Hi,

Thanks a lot for your suggestions.:)

I will open new thread for prism generation (non conformal interface).

Forum: ANSYS Meshing & Geometry

September 16, 2009, 00:56

Replies: 8

[ICEM] Coarse mesh nearer to curves

Views: 6,034

Posted By jsm

Hi Simon Pereira, Thanks for your...

Hi Simon Pereira,

Thanks for your kind reply. Now I understood the patch dependent mesh settings. :)

I have further few questions to you. When I am using ICEM CFD, I came...

Forum: ANSYS Meshing & Geometry

September 15, 2009, 03:07

Replies: 8

[ICEM] Coarse mesh nearer to curves

Views: 6,034

Posted By jsm

Hi Simon Pereira, Sorry for...

Hi Simon Pereira,

Sorry for the delayed response. I am unable to see your reply. I gave mesh size for all curves and enabled the "adapt mesh interior" option. Once again I did...

Forum: ANSYS Meshing & Geometry

September 11, 2009, 00:21

Replies: 8

[ICEM] Coarse mesh nearer to curves

Views: 6,034

Posted By jsm

Hi Simon Pereira, Thanks for your...

Hi Simon Pereira,

Thanks for your reply. My actual geometry is bigger and complex one. I explain my issue with simple cube geometry. There also I am getting same type of mesh.

...

Forum: ANSYS Meshing & Geometry

September 9, 2009, 07:24

Replies: 8

[ICEM] Coarse mesh nearer to curves

Views: 6,034

Posted By jsm

Coarse mesh nearer to curves

Hi,

In ICEM, I generated the tri surface mesh. But surface mesh is not uniform throughout the surfaces. In curves, the mesh is coarse. I tried one more time with following changes....

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 17:20.