Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: W.T.S

Forum: ANSYS Meshing & Geometry

June 1, 2011, 02:06

Replies: 6

[GAMBIT] negative volume by cooper?

Views: 1,880

Posted By W.T.S

Thank you！you're so kind to help me so much! ...

Thank you！you're so kind to help me so much!
i've followed what you told me in the last post to make a 0.1mm extrusion and managed to gain a good quality mesh for the 2 tangential volumes . As to...

Forum: ANSYS Meshing & Geometry

May 31, 2011, 08:17

Replies: 6

[GAMBIT] negative volume by cooper?

Views: 1,880

Posted By W.T.S

I've tried lots of times just as what you showed...

I've tried lots of times just as what you showed me. but i don't konw why it could't be properly meshed. i didn't remesh any source faces as the cooper sheme requires.
I've been successfully meshed...

Forum: ANSYS Meshing & Geometry

May 31, 2011, 07:40

Replies: 6

[GAMBIT] negative volume by cooper?

Views: 1,880

Posted By W.T.S

Sorry ,i'm still not clear, the top one and the...

Sorry ,i'm still not clear, the top one and the bottom one are the two faces of the same entity. when i use cooper and then select these two faces as the source faces, there produced negtive volume....

Forum: ANSYS Meshing & Geometry

May 31, 2011, 05:06

Replies: 6

[GAMBIT] negative volume by cooper?

Views: 1,880

Posted By W.T.S

negative volume by cooper?

Hi, dear -MAX-， hi everybody! I don't know why when i use the cooper tool in gambit's volume meshing, it produced many negtive volume even if it 's a rather simple entity. I'm here for help...7856

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 20:59.