CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Members List Search Today's Posts Mark Forums Read

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: Ruli
Forum: OpenFOAM Running, Solving & CFD March 30, 2014, 09:55
Replies: 11
Views: 2,418
Posted By Ruli
Dear Foamers, just to let you know: I got...

Dear Foamers,

just to let you know:
I got MRF running in combination with pimpleFoam in piso mode, as mentioned above by simple using fvOptions with the pimple solver.

Though, one problem...
Forum: OpenFOAM Running, Solving & CFD December 13, 2013, 04:49
Replies: 11
Views: 2,418
Posted By Ruli
I am working on cross flow and passive flow...

I am working on cross flow and passive flow control for reduction of cross flow.

Best regards
Julian
Forum: OpenFOAM Running, Solving & CFD December 13, 2013, 04:32
Replies: 11
Views: 2,418
Posted By Ruli
Thanks, I wasn`t aware of that! Should be written...

Thanks, I wasn`t aware of that! Should be written in the OF manual ;) There it only mentions simple and interFoam for MRF solving.

Best regards
Julian
Forum: OpenFOAM Running, Solving & CFD December 11, 2013, 06:27
Replies: 11
Views: 2,418
Posted By Ruli
Dear Foamers, any new thoughts on that? Would...

Dear Foamers,
any new thoughts on that? Would MRFInterFoam work? I guess, if I use only one fluid, it should give me a transient solver, with the cost off one additional transport equation for...
Forum: OpenFOAM Running, Solving & CFD October 15, 2013, 04:33
Replies: 11
Views: 2,418
Posted By Ruli
Hi Thomas, Thanks for the fast reply :) I...

Hi Thomas,
Thanks for the fast reply :)

I know about the basic concept of MRV, but as I understand the solution of the unsteady NS equation should not depend on wether the mesh is "solid" or...
Forum: OpenFOAM Running, Solving & CFD October 14, 2013, 13:09
Replies: 11
Views: 2,418
Posted By Ruli
Unsteady MRFSimpleFoam?

Hi Foamers,
I want to simulate a rotating wind turbine for my MA thesis, but before I start I would like to ask some question to set the direction of my efforts ;)

Because of avialable computing...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -4. The time now is 21:20.