Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: fauka

Forum: ANSYS Meshing & Geometry

June 11, 2009, 02:01

Replies: 4

[ICEM] Uncertainty about the mesh

Views: 2,918

Posted By fauka

Associating the edge with a curve is sufficient...

Associating the edge with a curve is sufficient to make the edge represent the curvature. But if the curvature complex with many twists, it will be a good idea to split the curve and make it a spline.

Forum: ANSYS Meshing & Geometry

June 10, 2009, 06:19

Replies: 4

[ICEM] Uncertainty about the mesh

Views: 2,918

Posted By fauka

Hi, 1. I think the surfaces are not...

Hi,

1. I think the surfaces are not matching with the curves just because of the problem in the graphics. Otherwise the mesh will be very bad near the boundaries.

2. Either ways is ok I...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 20:38.