Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: ThibaudB

Forum: OpenFOAM Meshing & Mesh Conversion

January 31, 2012, 08:24

Replies: 9

[snappyHexMesh] snappyHexMesh keeping internal geometry

Views: 4,840

Posted By ThibaudB

Hello Antonello, I don't know about...

Hello Antonello,

I don't know about SolidWorks, I myself kept on using SalomeMeca for simple geometries, avoiding problems with sHM then.
Could you post your STL file, and also your Salome file...

Forum: OpenFOAM Meshing & Mesh Conversion

January 30, 2012, 04:24

Replies: 9

[snappyHexMesh] snappyHexMesh keeping internal geometry

Views: 4,840

Posted By ThibaudB

Hello Antonello, well, I found some ways to...

Hello Antonello,

well, I found some ways to sove this problem, depending how complicated is the geometry.

First one was the use of a software to "extract" the faces out of my complex geometry...

Forum: OpenFOAM Meshing & Mesh Conversion

October 4, 2011, 06:33

Replies: 9

[snappyHexMesh] snappyHexMesh keeping internal geometry

Views: 4,840

Posted By ThibaudB

@niklas I did check it, and for some simple...

@niklas

I did check it, and for some simple geometries (like cylinders), I could get the two separated regions, but more complicated shapes were leading to the creation of "domains" when splitting...

Forum: OpenFOAM Meshing & Mesh Conversion

June 7, 2011, 04:53

Replies: 9

[snappyHexMesh] snappyHexMesh keeping internal geometry

Views: 4,840

Posted By ThibaudB

snappyHexMesh keeping internal geometry

Hi Everyone !

I am currently trying to run a conjugate heat transfer case based on building a Salome STL geometry, converting it to 2-D-compatible case using OpenFOAM through snappyHexMesh, and...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 04:48.