Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Ryan_Yang

Forum: ANSYS Meshing & Geometry

April 4, 2012, 07:43

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,180

Posted By Ryan_Yang

thanks again,Far ! I'll pay attention on the...

thanks again,Far ! I'll pay attention on the place you mentioned!

Forum: ANSYS Meshing & Geometry

April 4, 2012, 06:21

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,180

Posted By Ryan_Yang

thanks, everyone, especially Far:D. I've build...

thanks, everyone, especially Far:D. I've build the mesh under Far's instruction, and it turned to be very cool.
The video didn't just help me with this case, but also give me many inspiration about...

Forum: ANSYS Meshing & Geometry

April 3, 2012, 05:06

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,180

Posted By Ryan_Yang

Hi, Ali, thanks for your reply. I've tried as...

Hi, Ali, thanks for your reply. I've tried as you said, but fluent only recognize the 1st and 3rd inlet area, and the surface mesh look like the following pic(I've already set 3 different inlet in...

Forum: ANSYS Meshing & Geometry

April 2, 2012, 11:58

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,180

Posted By Ryan_Yang

How to build the mesh for 3 injection area within one surface?

Dear ICEM experts,
I'm trying to build mesh for the burner with 3 injection area in ICEM, the 3 different injection area are in the same surface and shown in the following pictures. There are no...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 04:43.