Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: m5edr

Forum: ANSYS Meshing & Geometry

November 6, 2012, 15:00

Replies: 7

[Other] Two different domain in Wind turbine

Views: 1,809

Posted By m5edr

Thanks Far I'm really appreciated your advices :)...

Thanks Far I'm really appreciated your advices :)

I ran the mesh with Interior before But after convergence of Fluent the results are not logic.... So I ran the mesh with Interface But Fluent...

Forum: ANSYS Meshing & Geometry

November 6, 2012, 14:37

Replies: 7

[Other] Two different domain in Wind turbine

Views: 1,809

Posted By m5edr

Thanks Far But I succeeded in make contact...

Thanks Far

But I succeeded in make contact boundaries as interior , Are you mean it will lead to wrong results

Forum: ANSYS Meshing & Geometry

November 6, 2012, 09:52

Replies: 7

[Other] Two different domain in Wind turbine

Views: 1,809

Posted By m5edr

Thanks Far for replay I had seen it before...

Thanks Far for replay

I had seen it before But this tutorial is 2D ... is this can apllied to 3D model where the contant zone is face not line?

Note for explanation you told be before in a...

Forum: ANSYS Meshing & Geometry

November 6, 2012, 08:12

Replies: 7

[Other] Two different domain in Wind turbine

Views: 1,809

Posted By m5edr

Two different domain in Wind turbine

Dear Experts

I want to know:

What type of contact should i use in mesh setup (interior or Interface b.c) in order to specify a common boundary between two different domain of same fluid in...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 07:28.