CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Members List Search Today's Posts Mark Forums Read

Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: sieginc.
Forum: STAR-CCM+ November 14, 2011, 17:14
Replies: 12
Views: 10,316
Posted By sieginc.
Thank you very much for the insight. I actually...

Thank you very much for the insight. I actually believe I may have found the culprit... my prism layer thickness was too great. I had them about the same size as what was in my volume control, and...
Forum: STAR-CCM+ November 13, 2011, 05:46
Replies: 12
Views: 10,316
Posted By sieginc.
OK I understand now. Well, I eliminated the...

OK I understand now. Well, I eliminated the problem of the cell count jumping by varying the base size. I do have a more general question relating to meshes and mesh size. I am relatively new to...
Forum: STAR-CCM+ November 7, 2011, 19:50
Replies: 12
Views: 10,316
Posted By sieginc.
If I wanted to keep the base size constant, could...

If I wanted to keep the base size constant, could I just switch the vol source size to relative, and vary that % instead?

Ex: base size 10 mm for all tests

Test 1: vol source size 50% relative...
Forum: STAR-CCM+ November 7, 2011, 03:57
Replies: 12
Views: 10,316
Posted By sieginc.
Thank you for the responses. If that's the case...

Thank you for the responses. If that's the case then that really hampers any attempt at a mesh refinement study, since I would only be able to test two mesh sizes of 5 mm and 2.5 mm. That does not...
Forum: STAR-CCM+ November 3, 2011, 20:57
Replies: 12
Views: 10,316
Posted By sieginc.
volumetric control total cell count

Here is a picture of the mesh I am using for my simulation:

http://img15.imageshack.us/img15/4571/meshissue.jpg

The base size is 10 mm, the size for the volume control is 2.5 mm and absolute....
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT -4. The time now is 07:50.