Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: FlowMe

Forum: STAR-CCM+

February 13, 2012, 21:57

Replies: 6

Having issues developing Mesh

Views: 5,349

Posted By FlowMe

well, your suggestions helped alot! I made...

well, your suggestions helped alot! I made progress!!

I actually found a problem when I was looking at each part, the elbow had a hole in it I was able to fill. I'm wondering if that wasn't a lot...

Forum: STAR-CCM+

February 9, 2012, 15:21

Replies: 6

Having issues developing Mesh

Views: 5,349

Posted By FlowMe

Hi, Thank you very much for your reply. ...

Hi,

Thank you very much for your reply.

However, it didn't work. I followed your instructions, I imported the model into the 3D-CAD_MODELER. It was an assembly that was imported, so it was...

Forum: STAR-CCM+

February 7, 2012, 23:34

Replies: 6

Having issues developing Mesh

Views: 5,349

Posted By FlowMe

Having issues developing Mesh

I will preface by saying I'm a newbie, but some of my peers can't quite figure it out either. I will explain as best I can.

I built an intake manifold and tube assembly in Pro/E, converted it to...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 19:22.