Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Nucleophobe

Forum: OpenFOAM Meshing & Mesh Conversion

August 20, 2012, 16:45

Replies: 4

[snappyHexMesh] Effect of adding layers with sHM

Views: 2,869

Posted By Nucleophobe

I finally figured out that I was just referencing...

I finally figured out that I was just referencing the wrong timestep with reconstructPar. I didn't realize that layer creation was done in timestep 3.

Thanks again,
-Ken

Forum: OpenFOAM Meshing & Mesh Conversion

August 10, 2012, 15:21

Replies: 4

[snappyHexMesh] Effect of adding layers with sHM

Views: 2,869

Posted By Nucleophobe

I uncommented the following section when...

I uncommented the following section when producing the mesh with layers turned on:
layers
{ // I remove these comments to enable layering on the cylinder surface
// cylinder_cylinder...

Forum: OpenFOAM Meshing & Mesh Conversion

August 10, 2012, 11:17

Replies: 4

[snappyHexMesh] Effect of adding layers with sHM

Views: 2,869

Posted By Nucleophobe

Effect of adding layers with sHM

I'm trying to better understand how to use layers with sHM and am hitting a dead end.

Here is a mesh of a single STL surface (a cylinder) with and without layer addition. The view shown is a...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 13:30.