Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: martyn88

Forum: ANSYS Meshing & Geometry

September 19, 2012, 05:21

Replies: 11

[ANSYS Meshing] LES mesh

Views: 3,585

Posted By martyn88

Getting there

Hi everyone,

I am making progress however I am still having trouble grading my mesh.

Is ICEM in any way like ansys mesher where you can define an edge and a bias ratio etc? Because basically...

Forum: ANSYS Meshing & Geometry

September 15, 2012, 03:34

Replies: 11

[ANSYS Meshing] LES mesh

Views: 3,585

Posted By martyn88

Thankyou Far and Diamondx! I really...

Thankyou Far and Diamondx!

I really appreciate it, I will run my simulation on the new mesh and see how it goes.

Forum: ANSYS Meshing & Geometry

September 14, 2012, 01:08

Replies: 11

[ANSYS Meshing] LES mesh

Views: 3,585

Posted By martyn88

So I had a look at the file you linked me. Can I...

So I had a look at the file you linked me. Can I create an o-grid on the 1/8th section I mentioned, ie would the square cells in the centre just be slightly skewed? I can not afford to mesh the...

Forum: ANSYS Meshing & Geometry

September 14, 2012, 00:59

Replies: 11

[ANSYS Meshing] LES mesh

Views: 3,585

Posted By martyn88

Wow, that would be amazing. I will attach my...

Wow, that would be amazing. I will attach my geometry file (IGES format, I hope that works) and if you could have a go in ICEM that would be great.

In the mean time I will persist with Ansys...

Forum: ANSYS Meshing & Geometry

September 13, 2012, 20:37

Replies: 11

[ANSYS Meshing] LES mesh

Views: 3,585

Posted By martyn88

Hi Ali, thanks for your reply. I used Ansys...

Hi Ali, thanks for your reply.

I used Ansys meshing however I am importing the mesh into OpenFOAM for solution.

I sliced near the centre-line then swept the top geometries (10 divisions in the...

Forum: ANSYS Meshing & Geometry

September 13, 2012, 11:36

Replies: 11

[ANSYS Meshing] LES mesh

Views: 3,585

Posted By martyn88

LES mesh

Hi everyone,

I am attempting to simulate a turbulent free jet using LES but am having some problems with my mesh.
To create a periodic section of the full 3D geometry I am sweeping a 2-D ...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 09:20.