Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: hansel

Forum: OpenFOAM Meshing & Mesh Conversion

July 4, 2009, 11:25

Replies: 5

[Technical] Uncovered faces found ????

Views: 3,775

Posted By hansel

I used blockMesh for the basic cylinder and...

I used blockMesh for the basic cylinder and block. Once I get this working, I plan to carve the test item out of the cylindar using snappyHexMesh.

By the way, if I can ever make this work, I'll...

Forum: OpenFOAM Meshing & Mesh Conversion

July 3, 2009, 23:53

Replies: 5

[Technical] Uncovered faces found ????

Views: 3,775

Posted By hansel

Okay, I made some progress. The uncovered faces...

Okay, I made some progress. The uncovered faces are just what it sounds like. When I made my face zones I included the top and bottom. I should have just had the mating faces. So that error is...

Forum: OpenFOAM Meshing & Mesh Conversion

July 3, 2009, 13:09

Replies: 5

[Technical] Uncovered faces found ????

Views: 3,775

Posted By hansel

BTW, the GGI questions and answers are spread all...

BTW, the GGI questions and answers are spread all over the place. I think there should be an OpenFOAM -> Meshes -> GGI / moving meshes section.

Forum: OpenFOAM Meshing & Mesh Conversion

July 3, 2009, 13:08

Replies: 5

[Technical] Uncovered faces found ????

Views: 3,775

Posted By hansel

Uncovered faces found ????

I'm using OpenFOAM-1.5-dev Ubuntu 9.04 64 bit.

I'm attempting to set up a rotating mesh, with a cylinder inside a block with a hole, just a little larger than the cylinder. (the cylinder is about...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 13:35.