Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: ali jafari

Forum: OpenFOAM Meshing & Mesh Conversion

October 7, 2013, 11:41

Replies: 8

[Commercial meshers] Gambit periodic convert to OF

Views: 1,899

Posted By ali jafari

I used Wall boundary condition in gambit and...

I used Wall boundary condition in gambit and changed it to cyclic after converting .

Forum: OpenFOAM Meshing & Mesh Conversion

October 6, 2013, 16:25

Replies: 8

[Commercial meshers] Gambit periodic convert to OF

Views: 1,899

Posted By ali jafari

in the link tool two check box exists.(periodic...

in the link tool two check box exists.(periodic and reverse) you must active these check boxes and you must select oriented of your face, correctly . this selection depends on geometry.

Forum: OpenFOAM Meshing & Mesh Conversion

October 6, 2013, 10:56

Replies: 8

[Commercial meshers] Gambit periodic convert to OF

Views: 1,899

Posted By ali jafari

hi Dear Kia unfortunately...

hi
Dear Kia
unfortunately ,Fluent3DMeshToFoam can not do it. I used Createpatch utility . and it work very good if you link boundary correctly in gambit.;)
But I strong recommend you use the...

Forum: OpenFOAM Meshing & Mesh Conversion

November 24, 2012, 10:57

Replies: 8

[Commercial meshers] Gambit periodic convert to OF

Views: 1,899

Posted By ali jafari

Thank you . yes it was a boundary condition...

Thank you .
yes it was a boundary condition problem , my problem got solve !

Forum: OpenFOAM Meshing & Mesh Conversion

November 24, 2012, 05:02

Replies: 8

[Commercial meshers] Gambit periodic convert to OF

Views: 1,899

Posted By ali jafari

Gambit periodic convert to OF

hi
I study flow between two concentric cylinders , I set top and bottom boundary conditions to periodic condition and use fluent3DMeshToFoam for converting *.msh . checkMesh is OK but when I run...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 06:14.