Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Crank-Shaft

Forum: ANSYS Meshing & Geometry

March 23, 2013, 21:24

Replies: 10

[ICEM] ICEM Beginner Help - Blocking 3D Vane Vortex Generator

Views: 3,255

Posted By Crank-Shaft

Hello everyone, I have been trying to...

Hello everyone,

I have been trying to conduct some grid independence studies and sensitivity studies with the ICEM meshes created with the Y-grid technique. Far, I currently prefer that first...

Forum: ANSYS Meshing & Geometry

March 19, 2013, 04:11

Replies: 10

[ICEM] ICEM Beginner Help - Blocking 3D Vane Vortex Generator

Views: 3,255

Posted By Crank-Shaft

Based on my limited knowledge it may be best for...

Based on my limited knowledge it may be best for you to start with the 2D geometry since it would make it easier to define all the boundary conditions, understand the basic flow features and also...

Forum: ANSYS Meshing & Geometry

March 18, 2013, 23:26

Replies: 10

[ICEM] ICEM Beginner Help - Blocking 3D Vane Vortex Generator

Views: 3,255

Posted By Crank-Shaft

That is fantastic work Far! I will try to emulate...

That is fantastic work Far! I will try to emulate this blocking strategy myself perhaps later on this week.

I was using index control and eliminating all the other blocks fore and aft of the main...

Forum: ANSYS Meshing & Geometry

March 18, 2013, 10:37

Replies: 10

[ICEM] ICEM Beginner Help - Blocking 3D Vane Vortex Generator

Views: 3,255

Posted By Crank-Shaft

I have some new updates to share with you all. ...

I have some new updates to share with you all.

I basically followed what Far suggested with the association of the edges, the merging of the vertices and the Y-grid. This produced some great...

Forum: ANSYS Meshing & Geometry

March 16, 2013, 23:36

Replies: 10

[ICEM] ICEM Beginner Help - Blocking 3D Vane Vortex Generator

Views: 3,255

Posted By Crank-Shaft

Thanks so much for the prompt reply Far. You're...

Thanks so much for the prompt reply Far. You're an absolute legend in my books!

The blocks above the VG definitely looks similar to my previous work in Workbench mesher. I had a lot of problems...

Forum: ANSYS Meshing & Geometry

March 16, 2013, 20:28

Replies: 10

[ICEM] ICEM Beginner Help - Blocking 3D Vane Vortex Generator

Views: 3,255

Posted By Crank-Shaft

ICEM Beginner Help - Blocking 3D Vane Vortex Generator

Hello fellow CFD-Onliners,

I have been studying vane-type vortex generators on an exposed ramp surface to understand the fundamental flow features downstream. This includes physical variables such...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 19:57.