CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Members List Search Today's Posts Mark Forums Read

Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: vrk
Forum: ANSYS Meshing & Geometry February 17, 2013, 19:10
Replies: 12
Views: 2,695
Posted By vrk
Far, I tried to mesh the Flat tube geometry...

Far,

I tried to mesh the Flat tube geometry in ICEM CFD. But, I am unable to specify nodes along the z-direction edges.Can you tell me where i am doing wrong.

Thanks for your help.

Ravi
Forum: ANSYS Meshing & Geometry February 8, 2013, 16:45
Replies: 12
Views: 2,695
Posted By vrk
Far, Could you please tell me how you meshed...

Far,

Could you please tell me how you meshed the 3-D falt tube geometry in ICEM CFD?I am new to this software as i started using it very recently. I really appreciate if you could tell how you did...
Forum: ANSYS Meshing & Geometry December 10, 2012, 17:29
Replies: 12
Views: 2,695
Posted By vrk
Far, Many thanks for your reply with attached...

Far,
Many thanks for your reply with attached figures. Did you mesh the face with out splitting it? or did you split the face into rectangular face and quarter circle face and then meshed them...
Forum: ANSYS Meshing & Geometry December 10, 2012, 17:16
Replies: 12
Views: 2,695
Posted By vrk
mAx, Thank you very much for your reply. When...

mAx,
Thank you very much for your reply. When i try to export the mesh in Gambit, it is giving me the warning sign "Volume. 1 is not meshed and is not exported". Also boundary conditions on Face....
Forum: ANSYS Meshing & Geometry December 9, 2012, 22:14
Replies: 12
Views: 2,695
Posted By vrk
meshing 3-D flat tube

Hello, I am trying to mesh a 3-D flat tube ( rectangular pipe with two semi-circular ends, please see fig. 1). I created and meshed the geometry in the following procedure:
1. created the inlet...
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT -4. The time now is 08:05.