Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: michael_owen

Forum: ANSYS Meshing & Geometry

October 27, 2010, 11:47

Replies: 9

3D wing + wind tunnel hexa structured meshing

Views: 7,398

Posted By michael_owen

You should embed your geometry into a relatively...

You should embed your geometry into a relatively small block, relatively close to the surface of the geometry, and tet mesh it. Embed this block in your far field domain, which will be easy to block...

Forum: ANSYS Meshing & Geometry

October 26, 2010, 09:05

Replies: 9

3D wing + wind tunnel hexa structured meshing

Views: 7,398

Posted By michael_owen

I would not recommend a hex mesh for this...

I would not recommend a hex mesh for this geometry. If you insist on one, you'll be forced to use ICEM, and good luck blocking it. If you haven't used ICEM in the past, it has a very steep learning...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 13:43.