Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: yorelchr

Forum: ANSYS Meshing & Geometry

December 2, 2012, 10:14

Replies: 10

[ICEM] O-grid strategy

Views: 1,642

Posted By yorelchr

ok problem solved !!! when coupling points for...

ok problem solved !!!
when coupling points for periodicity I was taking 4 points not on the same surface but on 2 adjacent surfaces.
thank you very much for your help!!!

Forum: ANSYS Meshing & Geometry

December 2, 2012, 05:23

Replies: 10

[ICEM] O-grid strategy

Views: 1,642

Posted By yorelchr

when I do a check geometry, ICEM automatically...

when I do a check geometry, ICEM automatically recreates me this part.00 with curves from the inside pipe and with wall.125 and wall.126. Can it be a problem with that, for example "double curves" ?...

Forum: ANSYS Meshing & Geometry

December 1, 2012, 14:41

Replies: 10

[ICEM] O-grid strategy

Views: 1,642

Posted By yorelchr

1. yes the mesh is quite bad, but it's just for...

1. yes the mesh is quite bad, but it's just for trying (I've spent time yesterday doing a "good" one to realise that Fluent couldn't read it so today I did all the blocking again without taking too...

Forum: ANSYS Meshing & Geometry

December 1, 2012, 13:01

Replies: 10

[ICEM] O-grid strategy

Views: 1,642

Posted By yorelchr

ciao Far, thank you for your reply. I...

ciao Far,

thank you for your reply.
I don't understand where I should put parameters for periodicity. In the BC panel I've put periodic but there's no way to specify the value of the angle....

Forum: ANSYS Meshing & Geometry

December 1, 2012, 11:16

Replies: 10

[ICEM] O-grid strategy

Views: 1,642

Posted By yorelchr

Here is the geometry with blocking and meshing. ...

Here is the geometry with blocking and meshing.
Can anyone tell me what is wrong with it since I can't open the mesh on Fluent.
PS: the mesh is not really good but it's just a try version for...

Forum: ANSYS Meshing & Geometry

December 1, 2012, 08:23

Replies: 10

[ICEM] O-grid strategy

Views: 1,642

Posted By yorelchr

ciao Ralen, sorry for replying so late, but...

ciao Ralen,

sorry for replying so late, but I had some other work to do and now I'm back again to this geometry. I've tried to send it to you but couldn't...I had the following message "invalid...

Forum: ANSYS Meshing & Geometry

November 28, 2012, 16:57

Replies: 10

[ICEM] O-grid strategy

Views: 1,642

Posted By yorelchr

O-grid strategy

Hello everyone,
I am trying to mesh a part of a geometry. I would like to use the block strategy or even O-block...but I am a bit lost and really "strange things" are coming out.
This is my...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 13:37.