Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: doctsh

Forum: FLOW-3D

August 10, 2010, 03:16

Replies: 7

mentor needed

Views: 2,301

Posted By doctsh

Hi grace01, would you please tell me what...

Hi grace01,

would you please tell me what you tried? how you know its working? please share it I am struggling for long time...

Forum: FLOW-3D

August 6, 2010, 00:59

Replies: 7

mentor needed

Views: 2,301

Posted By doctsh

Hi, I did them but no use. My doubt is as...

Hi, I did them but no use.

My doubt is as helix is moving forward, should i have to draw mesh with empty space to give space for moving and observe? or I can just use 'fit to geometry' mesh?
...

Forum: FLOW-3D

August 1, 2010, 10:18

Replies: 7

mentor needed

Views: 2,301

Posted By doctsh

Hi, as per your advice I did remove the fluid and...

Hi, as per your advice I did remove the fluid and ran. The calculation was over after 10 min and i didnot see any motion of stl.

I am running parallel 2-processors.

The mesh info is attached as...

Forum: FLOW-3D

July 29, 2010, 06:04

Replies: 7

mentor needed

Views: 2,301

Posted By doctsh

Thanks a lot. I am trying your suggestions now..

Thanks a lot. I am trying your suggestions now..

Forum: FLOW-3D

July 17, 2010, 06:36

Replies: 7

mentor needed

Views: 2,301

Posted By doctsh

efficiency of rotating helix

Hi everyone.

I have helix (stl)in fluid. It is given prescribed rotational motion. Due to this it gets coupled tranlational motion along axis. I want to know how much time or how many rotations...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 21:22.