Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Karatix

Forum: ANSYS Meshing & Geometry

November 8, 2009, 15:02

Replies: 15

[ICEM] C-Mesh, Blocking works, but export and import (to CFX) does not

Views: 6,698

Posted By Karatix

Hi Simon, sorry that it has been a while,...

Hi Simon,

sorry that it has been a while, but I kept testing it. Instead of extruding the mesh after the 2D Blocking I set it up as a 3D problem from the beginning.
I then used the volume mesher...

Forum: ANSYS Meshing & Geometry

October 21, 2009, 13:18

Replies: 15

[ICEM] C-Mesh, Blocking works, but export and import (to CFX) does not

Views: 6,698

Posted By Karatix

Hi Simon, after some more playing around, I...

Hi Simon,

after some more playing around, I found out that you have to add the blocks to the parts in order to be able to pick inlet, outlet within the CFX-Pre.
Another way is to define the...

Forum: ANSYS Meshing & Geometry

October 10, 2009, 12:28

Replies: 15

[ICEM] C-Mesh, Blocking works, but export and import (to CFX) does not

Views: 6,698

Posted By Karatix

Hi Simon, thank you for the advice. I will...

Hi Simon,

thank you for the advice. I will have a go at it and hope it will work this time. Btw, parts can also be lines and suround an area. Is this correct or do I have to create surfaces as...

Forum: ANSYS Meshing & Geometry

October 2, 2009, 05:15

Replies: 15

[ICEM] C-Mesh, Blocking works, but export and import (to CFX) does not

Views: 6,698

Posted By Karatix

How do you create Boundary conditions?

Hello Simon,

you were right. It works with Ansys CFX. I was able to write the input file and import it into CFX Pre. Thank you.

The only last little bit that does not seem to work as I like...

Forum: ANSYS Meshing & Geometry

October 1, 2009, 03:42

Replies: 15

[ICEM] C-Mesh, Blocking works, but export and import (to CFX) does not

Views: 6,698

Posted By Karatix

Hello Simon, thank you for your advice....

Hello Simon,

thank you for your advice. However, I aline the outer edges to the outer curves as you said. In addition the curves I created at the front, top and bottom are under Part Inlet and at...

Forum: ANSYS Meshing & Geometry

September 28, 2009, 03:33

Replies: 15

[ICEM] C-Mesh, Blocking works, but export and import (to CFX) does not

Views: 6,698

Posted By Karatix

C-Mesh, Blocking works, but export and import (to CFX) does not

Dear All,

currently I am using CFX 10.0 and ICEM 10.0.
My aim is to calculate the aerodynamic properties of an airfoil using a C-Mesh.
So far I managed to use the blocking mechanism to create a...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 11:43.