Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: braennstroem

Forum: OpenFOAM Pre-Processing

March 28, 2006, 09:43

Replies: 31

Velocity profile

Views: 10,158

Posted By braennstroem

Hi, I assume that can be do

Hi,

I assume that can be done using the 'vector(x,x,x)', like in:

INLET == 10 * pow(y*0.1,0.17) * vector (1,0,0);

This example writes just the u velocity.

Forum: OpenFOAM Pre-Processing

March 28, 2006, 09:02

Replies: 31

Velocity profile

Views: 10,158

Posted By braennstroem

Hi Anja, sorry, I did not c

Hi Anja,

sorry, I did not clean the code. I wrote this using 'trial&error' method with code snips from the board...

//VectorField& centresb = centres.boundaryField()[inletPatchID]; ...

Forum: OpenFOAM Pre-Processing

March 28, 2006, 06:15

Replies: 31

Velocity profile

Views: 10,158

Posted By braennstroem

Hi Anja, I am not sure, but

Hi Anja,

I am not sure, but I think you do not have to, because you refer to the 'inletPatchID'!?

Greetings!
Fabian

Forum: OpenFOAM Pre-Processing

March 24, 2006, 09:28

Replies: 31

Velocity profile

Views: 10,158

Posted By braennstroem

Hi, I have this folder in t

Hi,

I have this folder in the tutorial directory. Run 'wmake' in it; afterwards you should be able to use ssimpleFoam.

Usage: ssimpleFoam <root> <case> [-parallel]

Which changes the...

Forum: OpenFOAM Pre-Processing

March 23, 2006, 06:57

Replies: 31

Velocity profile

Views: 10,158

Posted By braennstroem

Hi, take a look at the disc

Hi,

take a look at the discussion:

http://www.cfd-online.com/OpenFOAM_Discus/messages/1/368.html?1142952871

with this I could write a nonuniform profile for my inlet. I attached my...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 12:01.