|
[Sponsors] |
speicfying massflow rate at inlet with pressure |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
Arun subramanian
Join Date: Jun 2016
Location: Florence,Italy
Posts: 48
Rep Power: 10 ![]() |
Hello!
I would like to simulate a test section in a windtunnel at 10 bars of pressure in Starccm+. The boundary conditions are Inlet : 10 Bar pressure , 200g/s through intlet Outlet: 10Bar ofcourse, the velocity at the intlet is not the same for 200g/s for 1Bar pressure and 10 bar pressure. I would like to know how I can specify the boundary conditions at the inlet. ![]() |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Member
Arun subramanian
Join Date: Jun 2016
Location: Florence,Italy
Posts: 48
Rep Power: 10 ![]() |
It was a very stupid question. I just had to set reference pressure to 10bars and its ok.
|
|
![]() |
![]() |
![]() |
Tags |
pressure bc, star ccm+ |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 12:23 |
outlet pressure Boundary settings -velocity streamline under ambient temp.conditions | Vishnu_bharathi | CFX | 12 | November 21, 2017 06:56 |
"Pressure Inlet" Boundary Setup | Wijaya | FLUENT | 15 | May 18, 2016 10:08 |
Calculate Density | mumtaz ersan | FloEFD, FloWorks & FloTHERM | 1 | September 17, 2015 04:26 |
Gate valve flow simulations... | nikesh | FloEFD, FloWorks & FloTHERM | 5 | January 28, 2014 01:31 |