|
[Sponsors] |
March 27, 2018, 10:55 |
Volume Fraction Source
|
#1 |
Member
fa
Join Date: Nov 2013
Posts: 30
Rep Power: 12 |
Can anybody explain to me what is the volume fraction source and how to define it?
is it a volumetric increase over time? |
|
March 28, 2018, 11:26 |
|
#2 |
Senior Member
André
Join Date: Mar 2016
Posts: 133
Rep Power: 10 |
Probably suggest to check out the guide. If it's a mass/volume source of some kind it can be constant (typically) or variable in time.
__________________
Sapere aude! |
|
March 30, 2018, 13:07 |
|
#3 |
Member
fa
Join Date: Nov 2013
Posts: 30
Rep Power: 12 |
I wish the guide was useful.
It does not explain it at all. It is a volume fraction source and not a volume/mass source it is defined as volume fraction /time |
|
June 10, 2021, 09:40 |
|
#4 |
New Member
Prasad ADHAV
Join Date: Apr 2020
Location: Belval, Luxembourg
Posts: 10
Rep Power: 6 |
I am also trying to add volume fraction source to interFoam.
I found some definition here, but I don't know if to denote this as a mass source or something else.(replacing `fvOptionName` Code:
<fvOptionName> { type volumeFractionSource; phase solid; phi phi; rho rho; U U; fields (rho U e); } |
|
December 8, 2022, 12:28 |
|
#5 |
New Member
Jakub Naider
Join Date: Oct 2022
Posts: 8
Rep Power: 3 |
Hello Prasad,
did you solve your problem ? I try to do the same stuff, but for reactingFoam. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] swak4foam for OpenFOAM 4.0 | mnikku | OpenFOAM Community Contributions | 80 | May 17, 2022 08:06 |
centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 01:41 |
friction forces icoFoam | ofslcm | OpenFOAM | 3 | April 7, 2012 10:57 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |