Home > Forums > Software User Forums > Siemens

Implicit droplet source terms (SW70,71)

Mark Forums Read

Reply

Search this Thread

December 11, 2000, 05:46	Implicit droplet source terms (SW70,71)	#1
Ossi Kaario Guest Posts: n/a	Hi, I have noticed that when using implicit source terms for the droplet mass and energy (SW70 and 71) I get a lot higher cylinder pressure in a engine combustion case compared to keeping them explicit. Has anyone noticed the same kind of behavior ? I do not immediately see where this effect comes from. Regards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Nonlinear problem with almost no implicit terms	rafal	OpenFOAM Running, Solving & CFD	4	April 24, 2008 08:11
Source terms	Virginie	FLUENT	1	December 19, 2007 02:00
Source Terms	Babar	FLUENT	0	September 11, 2007 01:11
Implicit or explicit treatment of convective terms	CH	Main CFD Forum	1	March 14, 2007 07:51
Point implicit treatment of k-e source terms	andy	Main CFD Forum	5	June 9, 2006 11:03

All times are GMT -4. The time now is 05:50.