 |
 |
 |
|
|
|
[Sponsors] | ||||
September 12, 2002, 19:14
|
moving mesh error
|
#1 |
|
Guest
Posts: n/a
|
I am trying to use subroutine newxyz to calculate the new location of vertices. But after I turn moving grid on in transient modules and when I check everything, there is a error 28: Transient data file is not connected. Who knows how to avoid this error? Thanks.
|
|
|
||
|
September 12, 2002, 21:56
|
Re: moving mesh error
|
#2 |
|
Guest
Posts: n/a
|
It seems that you do not open your transit data file *.trns. Try "module -> transit" open the menu of advanced transits, and connect or initialize your transit data.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| a error for moving mesh | RX | Siemens | 1 | December 7, 2006 13:29 |
| Error in moving mesh | Somnath | Siemens | 2 | January 20, 2005 11:49 |
| Error in moving mesh | sasikumar | Siemens | 0 | January 10, 2005 07:44 |
| Error while doing moving mesh | Harendra | Siemens | 2 | January 10, 2005 07:34 |
| moving mesh error. | dorain | Siemens | 0 | December 7, 2004 01:50 |
Linear Mode
