CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > Siemens

Restarting for problems with moving meshes

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   October 2, 2002, 11:27
Default Restarting for problems with moving meshes
  #1
Maya
Guest
 
Posts: n/a
Is there any other way to do restart for transient calculation with moving meshes then to use smap restart? Could I use my flow field from last iteration, for instance... Thanks for your time....
  Reply With Quote

Old   October 2, 2002, 15:02
Default Re: Restarting for problems with moving meshes
  #2
Joern Beilke
Guest
 
Posts: n/a
You can do a normal restart. Where is your problem?

Just add an additional load step if you want to change the boundary conditions (rdat init) does not work for moving mesh cases).
  Reply With Quote

Old   October 4, 2002, 04:51
Default Re: Restarting for problems with moving meshes
  #3
Maya
Guest
 
Posts: n/a
I don't want to change boundary conditions, my problem is a appropriate initial condition. When I did just restart, my mesh was complete mass, I had doubled time steps... Thanks a lot!!
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
VOF and moving meshes Dave FLUENT 0 May 7, 2007 02:54
Problem of restarting moving meshes with icoDyMFoam rolando OpenFOAM Bugs 8 March 23, 2007 07:18
Moving meshes charlotte Main CFD Forum 5 September 19, 2006 08:52
Moving meshes Kraev Stanislaw Main CFD Forum 2 April 11, 2003 14:09
Moving meshes, is that possible Stanislav Kraev Siemens 0 April 8, 2003 12:23


All times are GMT -4. The time now is 07:28.