|
[Sponsors] |
January 23, 2003, 10:59 |
to do a run in parallel mode with star_hpc
|
#1 |
Guest
Posts: n/a
|
Hello, I'm trying to do a run in parallel mode with star_hpc but I have found a problem with view factors. The error say:
"beam tracking is not supported in parallel - exiting", for 4 time, in fact I have decomposed the geometry file for 4 processors. The file .vfs must be created as a serial run after that I have put it on the directory that star_hpc has created. Have you any idea? Thank you in advance. |
|
January 23, 2003, 14:46 |
Re: to do a run in parallel mode with star_hpc
|
#2 |
Guest
Posts: n/a
|
Are you using participating or non-participating media? Participating media is not supported in parallel.
|
|
January 24, 2003, 05:06 |
Re: to do a run in parallel mode with star_hpc
|
#3 |
Guest
Posts: n/a
|
Hi Dino, I'm using non-participating in thermal options. What can I do? Thank you in advance. Bye
|
|
January 25, 2003, 13:49 |
Re: to do a run in parallel mode with star_hpc
|
#4 |
Guest
Posts: n/a
|
You need to run 1 iteration in serial in order to computer the radiation view factors. After they are computed, you should be able to continue the run in parallel.
|
|
January 30, 2003, 09:33 |
Re: to do a run in parallel mode with star_hpc
|
#5 |
Guest
Posts: n/a
|
Look at ma answer of Mo. 27. to your previous Question !
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A UDF Problem in Parallel Mode | Jun | FLUENT | 1 | October 26, 2011 13:49 |
DPM model in parallel batch mode | Prashanth | FLUENT | 2 | March 6, 2009 08:54 |
moving mesh in parallel mode | Karteek | Siemens | 4 | June 16, 2008 05:12 |
parallel mode - small problem? | co2 | FLUENT | 2 | June 2, 2004 00:47 |
How to run his phoenics in parallel mode? | Bryan Lam | Phoenics | 3 | December 19, 2001 10:43 |