|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi.. During iteration...I got a message in Browse additional output file.
"Warning #001 fluid inflow detected at some outflow boundaries where mass fluxes are forced to zero if this condition persists,your results might be wrong. The outflow boundary might not be well specified or the grid might be too corse near the out flow boundary" My grid is not corse.. What I need to do... thank for your help. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Try a pressure condition in place of outlet or extend the length of your domain.
HV |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
correct, it not allowed to put an outlet b.c. in a recirculation zone. try a pressure b.c. or extend the domain as HVN proposed
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Isn't it influenced on reference pressure cell??
thank you for your answer. |
|
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
no
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
VOF diffuse problem on two fluids problem | Fang Jin | FLUENT | 5 | February 17, 2011 06:38 |
Problem in Modelling Heat Transfer Problem | Deepak R | FLUENT | 1 | December 6, 2007 10:37 |
Problem in cavity flow problem | saad | Main CFD Forum | 4 | November 1, 2007 08:45 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 07:29 |
problem in solving "wave generation" problem | san | FLUENT | 2 | April 4, 2006 00:37 |