|
[Sponsors] |
April 11, 2003, 07:11 |
inlet
|
#1 |
Guest
Posts: n/a
|
Hay I am trying to set boundary conditions of 'fully developed flow' at the square duct inlet without preliminary calculation. How can I set the BC's. Thanks.
|
|
April 22, 2003, 14:08 |
Re: inlet
|
#2 |
Guest
Posts: n/a
|
methodology manual p 5-6 says for one layer of cells in the streamwise direction, impose a uniform pressure boundary on the 'inlet' plane and a prescribed flow outlet condition on the outlet plane
allan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
velocity inlet vs pressure inlet | cheong | FLUENT | 6 | April 9, 2011 04:07 |
subsonic inlet or supersonic inlet? | mali | CFX | 0 | November 28, 2008 21:57 |
about inlet bc | ivanyao | OpenFOAM Running, Solving & CFD | 0 | November 25, 2008 04:17 |
reversed flow at velocity inlet / mass flow inlet | ib | FLUENT | 1 | March 26, 2007 14:11 |
How to set smoke inlet speed on inlet | Adam | FLUENT | 0 | October 4, 2005 09:18 |