CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Siemens (
-   -   Total pressure to static pressure ratio (

roadracer April 16, 2003 10:05

Total pressure to static pressure ratio
Hi all. I have the following problem: flowbox of an engine manifold, Inlet BC stagnation, outlet BC pressure.Turbulent (ke) compressible flow. The reference pressure is 98000Pa, and the reference cell is on the pressure boundary. The total pressure is 2000Pa (relative). The calculations seems to run properly till convergence, but the output values of pressure are strange, and I have the warning message "ratio of total to static pressure (at stagnation boundary)less than 1..." The total pressure at inlet is 101432,static pressure at inlet is 101233. How can it be possible?

Jing April 17, 2003 05:31

Re: Total pressure to static pressure ratio
Have you check the ratio of every cell in the inlet?

All times are GMT -4. The time now is 06:36.