|
[Sponsors] |
May 18, 2003, 12:29 |
extrusion
|
#1 |
Guest
Posts: n/a
|
Hay ihave a cylinder model with complex mesh, i like to make a mesh extrusion in z direction with starcd. how i can do that. thanks
|
|
May 18, 2003, 18:40 |
Re: extrusion
|
#2 |
Guest
Posts: n/a
|
||
May 20, 2003, 16:57 |
Re: extrusion
|
#3 |
Guest
Posts: n/a
|
look at the command vcex!!!
Allan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Axisymmetric extrusion | Corentin | Siemens | 4 | December 14, 2007 12:53 |
What is the extrusion layer | Radhika | Siemens | 5 | February 2, 2007 18:06 |
mesh extrusion | giri | Siemens | 2 | November 13, 2006 06:02 |
Extrusion along a spline | tom | Siemens | 3 | February 1, 2002 09:08 |
Extrusion Modeling | Elliot Schwartz | Main CFD Forum | 1 | September 11, 1998 20:08 |