Home > Forums > Software User Forums > Siemens

HELP: moving mesh, postprocessing

Mark Forums Read

Reply

Search this Thread

June 5, 2003, 21:09	HELP: moving mesh, postprocessing	#1
Sunlight007 Guest Posts: n/a	hello, transient moving mesh, i use NEWXYZ, no event module. At post processing response to GETC ALL is **WARNING - CELL VARIABLE U IS NOT ON THE DATA FILE and so on. how to get the data? Thanks a lot

June 6, 2003, 10:31	Re: HELP: moving mesh, postprocessing	#2
John Guest Posts: n/a	Using GETV COOR for new coordinates before GETC

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can OpenFoam extract the surfaceinterface mesh for postprocessing	paean	OpenFOAM Post-Processing	1	December 9, 2008 15:49
[OpenFOAM] PostProcessing of a tworegion mesh	cosimobianchini	ParaView	9	October 10, 2008 05:52
Moving Reference frame - UDF - Moving mesh	modisa	FLUENT	0	April 18, 2008 13:31
[Commercial meshers] Questions in mesh converstion and postprocessing	BANNARI (Bannari)	OpenFOAM Meshing & Mesh Conversion	0	March 3, 2005 07:23
Moving Mesh & Not Rotating Mesh	AB	Siemens	1	October 25, 2004 03:10

All times are GMT -4. The time now is 08:35.