Problems saving graph registers data
Prostar doesn't save graph registers data. It just creates an empty file case.grf.
|
Re: Problems saving graph registers data
Hi Julie!
You just have to save it two times, then it should work. I think itīs a bug in the program. mfg Timo |
Re: Problems saving graph registers data
Hi Timo,
Thanks for your advise, but it doesn't work... |
Re: Problems saving graph registers data
You need to CLOSE the file first, otherwise ProSTAR will just keep it in memory until you exit (at which point the .grf file will be also fully written down to disk).
eg. CLOS "XYX.GRF" |
Re: Problems saving graph registers data
I think it is important to give exactly the right number of registers to be saved. If you have 4 registers with data you want to save, saving doesn't work when you write 5 in the box for "number of registers" to be saved. I had the same problem and this was the solution for it in my case.
|
All times are GMT -4. The time now is 20:19. |